If you ’re the favorable owner of a DualSense Edge restrainer then you are in all likelihood already cognizant of how customisable it is .
One of the vainglorious change , when compare to the vanilla extract DualSense controller , is the chance to remove and replace the joystick capital using the three caps included in the case .
We ’re going to be breaking down how you’re able to remove and substitute these caps in a simple stair - by - footprint process so you’re able to make the most out of your DualSense Edge restrainer straight out of the corner .
What you’ll need:
The Short Version
Step 1.
Gently pull up the joystick cap until you hear a click
Take your DualSense control in your deal and gently pull up on the joystick cap until you hear a clicking noise . You will require to use some force but it should not feel like you are doing any damage to the controller .
Step 2.
Once it has disconnected, gently remove it from the controller
Once you try the dog , you’re able to slip it aside from the controller .
Step 3.
Pick a new joystick cap
From the three joystick caps included with the DualSense Edge , pick a new cap .
Step 4.
Align the new joystick cap with the controller
Pick up your newfangled cap and trace up the bottom of the detonator with the joystick module .
Step 5.
Push down gently until you hear a click
You will want to apply some force to connect the joystick cap to the controller . Again , it should not finger like you are about to break the controller , although you will need to use a little bit of force .
Step 6.
Repeat these steps on the second joystick cap
Once you have successfully remove and added a newfangled joystick cap , you could repeat these whole tone and do the same to the second joystick on the accountant . This can be done as many times as you want .
Troubleshooting
The DualSense Edge comes with three joystick jacket option let in normal , low and high - dome variations .
Yes , you could check out ourexplainer hereto find out how to replace the joystick modules .
